• Water-based primer g/BA
• EU limit value for this product since 2010: 30 g / l
• TR - ISILOX contains maximum VOCs 22 g / l

If necessary, clean with specific products depending on the surface to be treated to eliminate any traces of dirt.
Then brush to remove dust from the surface.
Make sure that the surface to be treated is perfectly dry.

• Make sure that the surface is clean, well cured and perfectly dry in depth;
• Apply a coat of TR - ISILOX in the quantity necessary for the complete saturation of the surface until the rejection of the
  product by the support.
  Do not apply further coats of the product when the drying phase has already begun, excesses of the product can create halos.

• If necessary, dilute the product in the percentages indicated to facilitate application and distension.
• Mix well before use;
• Do not apply with air and / or substrate temperatures below + 8 ° C or above + 35 ° C;
• Do not apply with relative humidity higher than 80%;
• Do not apply on walls exposed to direct sunlight;
• Do not apply in anticipation of rain;
• Do not interrupt the application if the wall is not completed.
• Store the product without dilution water in a sealed container placed in a cool, dry place away from heat sources.

Sufficiently ventilate the room after painting before staying there again.
Dispose of empty containers according to local regulations.
For further information consult the relative safety data sheet.

The information contained in this sheet is only the result of the knowledge available at the date of the same by the manufacturer.
No responsibility is assumed for damage to persons or property resulting from improper use of this information.
The manufacturer reserves the right to change the data without notice.