TERMOFIX

fissativo termico

TERMOFIX

Fissativo termico consolidante formulato con resine acriliche e particolari microsfere termoisolanti che conferiscono al prodotto doti termiche idonee ad aumentare l’efficacia delle finiture termoisolanti sia all’interno che all’esterno

  • SUPPORTS

    Plaster, cement, bituminous sheath, fiber cement panels, plasterboard

  • APPLICATION

    Vertical and horizontal

  • SETTINGS

    Indoor / Outdoor

  • YIELD

    25 mq / lt

  • WATER BASED

  • SOLVENT FREE

  • ENERGY SAVING

  • EXCELLENT PERFORMANCE

fissativo termico

Specifications

TECHNICAL FEATURES (Main data measured at 20 ° and with relative humidity lower than 75 A

 

Appearance and finish

  

.Transparent
 

Colors / Bases

  

Colorless
 

Application supports

  

Inside / Outside
 

Nature of the binder

  

acrylic
 

.Theoretical yield by hand

  

about 45 - 50 sqm / l
(with 1 liter of product diluted 1: 6)
Application and dilution by brush or roller

Concentrated solution to be diluted in water in ratio
 

Cleaning of tools

  

With drinking water
 

Dry to the touch

  

max 1 h
 

Overpaintable

  

4 – 6 h
 

Complete drying

  

24 h
 

.Specific weight

  

1,00 A/- 0,05 g/ml
 

Viscosity

  

1.200 – 2.500 cps
 

Storage life

  

24 months (in a cool and dry place

 

Packs

  

Liters 1 - 5

VOC CLASSIFICATION (Directive 2004/42 / EC Law Decree No. 161/2006

  • WATER-based fixative primer h / BA
  • EU limit value for this product since 2010: 30 g / l
  • TERMOFIX contains maximum VOCs 10 g / l

PREPARATION OF THE SUBSTRATES

Make sure that the plasters are mature, dry, clean, free of dust and poorly consistent parts. If present, remove the parts of old paint or plaster that are flaking off. In the presence of mold, treat the surface with a specific product of good quality.

Remove any efflorescence present by brushing. Fill with good quality filler and sand the imperfections or if necessary, in cases of high thickness, restore with specific mortars respecting the drying times

APPLICATION PROCEDURE

After preparing the substrate and its complete drying, proceed with the application of TERMOFIX appropriately diluted following the dilution instructions. Apply the second coat only if necessary

(on highly absorbent substrates after 6 - 8 hours.

USEFUL TIPS / WARNINGS

Dilute the product in the percentages indicated according to the conditions of the substrate. Mix well before use.

Do not apply with ambient and / or substrate temperatures below + 8 ° C or above + 35 ° C. Do not apply with relative humidity of the environment higher than 80%.

Store the product without dilution water in a sealed container placed in a cool, dry place away from heat sources.

SAFETY INSTRUCTIONS

.If the application takes place indoors, ventilate the room sufficiently after painting before staying there again.

Dispose of empty containers according to local regulations.

.For further information consult the relative safety data sheet.

NOTES

The information contained in this technical data sheet is provided to the best of the manufacturer's scientific and technical knowledge. However, they do not constitute a guarantee of results as the conditions and methods of application are beyond any control. It is advisable to always evaluate the actual suitability of the product for each specific case and to comply with the usage requirements indicated in the technical data sheet.

Subscribe to the newsletter