• Two-component high-performance paints j / BA
• EU limit value for this product since 2010: 140 g / l
• TR - RES 1N PR contains maximum VOCs 110 g / l

Pour COMPONENT B into the container of COMPONENT A (to recover the residues of the jar of COMPONENT B use part of the dilution water).
Mix well until a homogeneous product is obtained, after mixing proceed with dilution.

Ratio of catalysis and dilution A / B / water: 100/25/125
Component A 1 liter + Component B 250 ml + Water 1250 ml
Component A 3 liter + Component B 750 ml + Water 3750 ml
Component A 9 liter + Component B 2250 ml + Water 11250 ml

NEW CONCRETE FLOOR:
Only intervene after the cement has cured (about 2 months).
Make sure there is no rising damp due to capillarity and release substances (waxes, silicones) that can counteract the adhesion of the resin.
Helicopter industrial concrete: abrade the surface after sanding to eliminate the shiny surface layer. Dedust. Non-helicopted concrete: treat the surface with a 1-2% hydrochloric acid solution and leave to act until no gaseous bubbles develop; rinse thoroughly with water making sure there is no more acid.
Leave to dry for 24 - 48 hours.

DETERIORATED OR ALREADY PAINTED CONCRETE FLOOR:
Remove any non-adherent parts or peeling paint and restore with specific mortars for low thicknesses. If necessary, carry out a sanding to roughen the surface, thus allowing better adhesion. Wash with water and detergents to remove dirt and grease.
Rinse thoroughly with water and leave to dry for 20 - 24 hours.

On adequately prepared surfaces, apply a coat of suitably catalysed and diluted TR-RES 1N PR COMPONENTE A + B. If necessary, in the case of substrates with high absorption, apply a second coat of TR-RES 1N PR COMPONENTE A + B 3 - 12 hours after the previous one.
On non-absorbent substrates such as tiles, marble, etc. no primer is required.

• Mix well before use;
• Avoid the formation of water stagnation in the first week after application
• If necessary, dilute the product in the percentages indicated to facilitate application and distension.
• Do not apply with air and / or substrate temperatures below + 10 ° C or above + 35 ° C;
• Do not apply with residual humidity of the substrate higher than 5%.
• Do not apply with relative humidity higher than 80%;
• Do not apply externally
• Store the product without dilution water and uncured in a sealed container placed in a cool, dry place away from heat sources.

Sufficiently ventilate the room after painting before staying there again.
Dispose of empty containers according to local regulations.
For further information consult the relative safety data sheet.

The information contained in this sheet is only the result of the knowledge available at the date of the same by the manufacturer.
No responsibility is assumed for damage to persons or property resulting from improper use of this information.
The manufacturer reserves the right to change the data without notice.