• i – g/(m2d) 3.99
• sd – m 62.16

• External wall paints of mineral development Base ACQUA c / BA
• EU limit value for this product since 2010: 40 g / l
• TR-CEMENT PRO contains maximum VOC <20 g / l

NEW OR UNPAINTED SURFACES
make sure the surface is dry, clean and well cured.

DETERIORATED SURFACES
brush to remove any loose debris or crumbling parts in the detachment phase - restore the concrete with fiber-reinforced mortar covering any exposed reinforcing bars - consolidate the entire surface with good quality PRIMER fixative.

Make sure the surface is properly prepared.
Apply two or three coats of TR-CEMENT PRO with an interval of about 10-12 hours between each other.

The coloring is achievable through the tintometric system.
In the case of coloring of several packs of the same color it is advisable to use bases from the same production batch.
In case this is not possible to mix the various productions together in order to avoid any differences in tone;

• If necessary, dilute the product in the percentages indicated to facilitate application and distension.
• Mix well before use;
• Do not apply with air and / or substrate temperatures below + 8 ° C or above + 35 ° C;
• Do not apply with relative humidity higher than 80%;
• Do not apply on walls exposed to direct sunlight;
• Do not apply in anticipation of rain;
• Do not interrupt the application if the wall is not completed;
• Store the product without dilution water in a sealed container placed in a cool, dry place away from heat sources.

Sufficiently ventilate the room after painting before staying there again. Dispose of empty containers according to local regulations. For further information consult the relative safety data sheet.

The information contained in this sheet is only the result of the knowledge available at the date of the same by the manufacturer.
No responsibility is assumed for damage to persons or property resulting from improper use of this information.
The manufacturer reserves the right to change the data without notice.